2 inch Mini Crank

  •  - Click to enlarge
  •  - Click to enlarge
  •  - Click to enlarge
2 inch Mini Crank

Tap for gallery

$149.95


Product Information
Specification

2 Inch Mini Crank

  • Works as either a floater or a sinker using urethane casting resin with or without microspheres. 
  • If using microspheres it is also recommended to use a resin with a longer pot life to facilitate pouring the thicker material. 
  • I found this crank works best with a small ballast weight near the bottom of the belly.  
  • I offer an OPTIONAL basic wire form guide or you can choose your own method of making the wire form to go in the mold before casting.
  • The wire slots are sized at about 0.041 to use inexpensive stainless safety wire, but in areas where that is not available you can use other appropriately sized wire that you can form to fit.  1mm wire has been used with success by some mold owners. 
  • This is designed to work with the Lure Parts Online (tm) 4053 7/8 by 3/8 Small Lure Lips.  


*** WARNING WARNING WARNING ***

Urethane (and other resins) stick strongly to aluminum.
YOU MUST USE A SUITABLE MOLD RELASE ON ALL SURFACES WHEN CASTING HARD RESINS IN ALUMINUM MOLDS.  
(I suggest a light coating on all the surface of the mold inside and outside so the ooze out and over flow mistakes do not stick permanently.)

I WILL NOT WARRANTY YOUR MOLD IF YOU GLUE IT SHUT.  

Product Code2inMiniCrank
ManufacturerCNC Molds N Stuff
ConditionNew
Weight1lb

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

eCommerce by CubeCart